Power Supply - Bresser NATIONAL GEOGRAPHIC 9070400 Instrucciones De Uso

13. MAX/MIN button
14. RCC button
15. °C/°F button
16. (16.) RESET knob
17. OFF/LO/HI slide switch
18. Power jack
19. Battery compartment
Remote sensor (Fig. 3)
20. Red LED indicator
21. Mounting base
22. RESET button
23. CH Channel slide switch
24. Battery compartment
BEFORE YOU START
IMPORTANT!
1. Insert batteries for main unit before doing so for the remote units.
2. Place the main unit as close as possible to the remote unit.
3. Position the remote unit and main unit within the effective
transmission range.
When changing batteries always change batteries in the
main unit as well as all remote units and replace them in the
correct order, so the remote connection can be re-established.
If batteries are exchanged in only one of the devices (i.e. the
remote sensor) the signal can't be received or can't be received
correctly.
Note, that the effective range is vastly affected by building
materials and position of the main and remote units. Due to
external influences (various RC devices and other sources of
interference), the maximum distance can be greatly reduced. In
such cases we suggest to position the main unit and the remote
sensor at other places. Sometimes all it takes is a relocation of
one of these components of a few inches!
Though the remote unit is weather proof, it should be placed
away from direct sunlight, rain or snow.

POWER SUPPLY

Main station
1. Put the power plug (Fig. 1, C) in the power jack (Fig. 2, 18).
2. Push the RESET knob to initialize the automatic time signal
and remote sensor signal seanning.
3. Open the battery compartment covering carefully with a coin
(turn to arrow direction OPEN).
4. Insert 1 button cell (Typ CR2032, 3V) according to the polarity
marked in the battery compartment.
5. Close the battery compartment.
DE
EN
ES
15