Installation Procedure; Important - Toto Aquia TL416SDH Manual De Instrucciones Y Del Propietario

Grifo de lavabo individual

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Important:

The pressure resistant flex hoses are packed

fully assembled with proper adhesive ap-

plied to the parts during assembly. Do not

loosen the hex nut when installing the fau-

cet.

1) Insert the flex hoses through the

hole in the deck one at a time.

2) Insert the lift rod from the backside

of the faucet.

3) Slide the bracket into place and

secure the spout with the locknuts.

4) Adjust the spout to face forward.

Hold the spout in place and tighten

the locknuts to secure it.

5) Connect the flex hoses to the supply

lines. Make sure the left hose connects

to the hot water supply line and right to

the cold water supply line.

1) Apply pipe tape to the flange

threads.

2) Insert the flange into the drain hole.

3) Assemble the gasket, flange nut and

lock nut.

4) Place the drain body onto the flange.

5) Secure the drain assembly by tight-

ening the flange nut and locknut.

6) Apply pipe tape to the threads of the

tail piece and install the tail piece to

the drain body.

7) Insert the drain stopper into the

flange.

8) Assemble the pivot rod as shown in

the diagram at the right.

9) Insert the pivot rod into the drain

stopper hole. Tighten the lock nut.

10) Insert the lift rod and pivot rod into

the connecting block. Tighten both

rods with a screwdriver.