Installation Procedure - Toto Connelly TL221DD Manual De Instrucciones Y Del Propietario

INSTALLATION PROCEDURE - Valves
1. Thread a mounting nut to the bottom
of the valve. Place a washer and gasket
as shown.
NOTE: the hot water valve has a red
marking on side of body.
2. Pass the valve up through the
installation hole.
Secure with mount collar until hand
tight, ensure O-ring is seated in
groove under collar.
3. Fixate the valve by threading the
mounting nut up the valve until hand
tight. Tighten the retaining screws
equally to secure.
Do not overtighten!
4. Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to water supply lines not included.
INSTALLATION PROCEDURE - Spout
5. Ensure O-ring is seated in groove
under sprout.
Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.
Mounting
Screws
4
Gasket
Gasket
(Rubber)
(Rubber)
Washer Washer
(Metal) (Metal)
Mounting
Mounting
Nut
Nut
Collar
O-ring
Spout
O-ring