Futurelight PHW-250 Manual Del Usuario página 42

♦ Press [ENTER], the display shows"ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] or [EXIT/DN] to exit.
rDIM
- Dimmer Reverse
With this function you can reverse the Dimmer from 100-0 % to 0-100 %.
♦ Select "RDIM" by pressing [UP] button.
♦ Press [ENTER], the display shows"ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] or [EXIT/DN] to exit.
- Switch 16 bit/8 bit
With this function you can switch the device from 16 bit to 8 bit resolution.
♦ Select "16BI" by pressing [UP] button.
♦ Press [ENTER], the display shows"ON" or "OFF".
♦ Press [UP] to select "ON" in order to set 16 bit, or "OFF" in order to set 8 bit. The channels PAN Fine
and TILT Fine will be disabled.
♦ Press [ENTER] or [EXIT/DN] to exit.
Rest
- Reset
With this function you can Reset the device via the Control Board.
♦ Select "rEST" by pressing [UP] button.
♦ Press [ENTER], the display shows"ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] or [EXIT/DN] to exit.
- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the
default values (shaded). Any edited scenes will be lost.
♦ Select "LODA" by pressing [UP] button.
♦ Press [ENTER], the display shows"ON" or "OFF".
♦ Press [UP] to select "ON" if you wish to enable this function or "OFF" if you don't.
♦ Press [ENTER] to confirm.
♦ Press [EXIT/DN] in order to return to the main menu.
Ver
- Software version
With this function you can display the software version of the device.
♦ Select "VER" by pressing [UP] button.
♦ Press [ENTER], the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0", "V-2.6".
♦ Press [ENTER] or [EXIT/DN] in order to return to the main menu.
- Main menu 3
♦ Press [ENTER] for 3 seconds to enter the main menu (display flashing).
♦ Press [UP] to select "ADJU".
- Lamp adjustment
With this function you can adjust the lamp via the Control Board. The shutter opens and the lamp can be
adjusted. In this mode, the device will not react to any control signal.
42/91 51838700X18NXS_V_1_3.DOC