Tabla de contenido
Idiomas disponibles
Idiomas disponibles
and safer at the rate for which it is designed.
17. Do not use tool if switch does not turn it on or
off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
18. Disconnect the plug from the power source
before making any adjustments, changing
accessories,
preventive safety measures reduce the risk of
starting the tool accidentally.
19. Store idle tools out of reach of children and
other untrained persons. Tools are dangerous in
the hands of untrained users.
20. Maintain tools with care. Keep cutting tools
sharp and clean. Properly maintained tools with
sharp cutting edges are less likely to bind and are
easier to control.
21. Check for misalignment or binding of moving
parts, breakage of parts, and any other
condition that may affect the tool's operation.
If damaged, have the tool serviced before
using. Many accidents are caused by poorly
maintained tools.
22. Use only accessories that are recommended
by
the
manufacturer
Accessories that may be suitable for one tool,
may become hazardous when used on another
Ampere Rating
More Than
0
6
10
12
000173
GROUNDING INSTRUCTIONS:
This tool should be grounded while in use to protect
the operator from electric shock. The tool is
equipped
with
a
three-prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire.
Never connect the green (or green and yellow) wire
to a live terminal. Your unit is for use on 120 volts
and has a plug that looks like Fig. "A".
or
storing
the
tool.
for
your
Table 1: Minimum gage for cord
Not More Than
6
10
12
16
three-conductor
cord
tool.
SERVICE
23. Tool service must be performed only by
qualified
maintenance performed by unqualified personnel
could result in a risk of injury.
Such
24. When servicing a tool, use only identical
replacement parts. Follow instructions in the
Maintenance section of this manual. Use of
unauthorized
Maintenance instructions may create a risk of
electric shock or injury.
USE
PROPER
three-wire extension cords that have three-prong
grounding-type plugs and three-pole receptacles
that accept the tool's plug. Make sure your extension
cord is in good condition. Replace or repair
damaged or worn cord immediately. When using an
extension cord, be sure to use one heavy enough to
carry the current your product will draw. An
undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. Table 1
shows the correct size to use depending on cord
model.
length and nameplate ampere rating. If in doubt, use
the next heavier gage. The smaller the gage number,
the heavier the cord.
Volts
120 V
25 ft.
18
18
16
14
Fig. A
and
Grounding
000088
3
repair
personnel.
parts
or
EXTENSION
Total length of cord in feet
50 ft.
100 ft.
AWG
16
16
16
14
16
14
12
Not Recommended
Cover of Grounded
Blade
Service
or
failure
to
follow
CORD.
Use
only
150 ft.
14
12
12
Outlet Box
Tabla de contenido
