Makita GA7911 Manual De Instrucciones página 5

Shaft lock
1
001028
CAUTION:
Never actuate the shaft lock when the spindle is
•
moving. The tool may be damaged.
Press the shaft lock to prevent spindle rotation when
installing or removing accessories.
Switch action
2 1
001043
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the trigger. Release the
trigger to stop. For continuous operation, pull the trigger
and then push in the lock button. To stop the tool from
the locked position, pull the trigger fully, then release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Shaft lock
1. Switch trigger
2. Lock button
5
Installing side grip (handle)
001059
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing abrasive disc (optional
accessory)
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
001114
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
001621
To remove the disc, follow the installation procedure in
reverse.
1. Lock nut
1
2. Abrasive disc
2
3. Rubber pad
3
1. Lock nut wrench
2. Shaft lock