Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE & OPERATION (CONTINUED)
CLEANING & DRAINING THE WATER TANK
If the cooler will not be used for a long period of time, please refer to the STORAGE & MAINTENANCE
GUIDELINES located in the separate Safety & Maintenance Guide.
WARNING:
Before cleaning the unit, switch the unit OFF and disconnect from the electrical socket.
•
Move the unit to a location where the water can be drained. Remove the cap from the Drain plug
located at the bottom of the unit. Allow the tank to empty.
•
Refill the water tank with clean water, up to the maximum level and drain it completely.
•
Use a damp cloth to remove the dirt and dust from the surface of the unit. Never use corrosive
elements or chemicals to clean this product.
•
When the product is not in use, store the unit in a dry place out of direct sunlight.
CLEANING THE PLASTIC NET FILTER* AND HONEYCOMB COOLING MEDIA
•
The appliance is supplied with a Plastic Net Filter* and
Honeycomb Cooling Media.
•
The Plastic Net Filter* and Honeycomb Cooling Media
are located inside the Rear Grill. See Figure 1 for
instructions on how to remove them from the unit for
cleaning and maintenance.
•
Do not run the unit in COOL mode with stale water in
the tank. You must empty the water tank and refill with
fresh water, especially if the tank has not been cleaned
in a long time.
•
The cleaning frequency for the Honeycomb media
depends on local air and water conditions. In areas
where the mineral content of water is high, mineral
deposits may build up on the Honeycomb Cooling
Media and restrict air flow. Draining the water tank and
refilling with fresh water at least once a week will help
reduce mineral deposits. If mineral deposits remain on
the Honeycomb Cooling Media, the media should be
removed and washed under fresh water. The media
should be cleaned every two months or sooner,
depending on your needs.
•
For best results allow the Honeycomb Cooling Media to
dry after each use by turning off the cool function 15
minutes before turning the unit off.
Figure 1:
Removing the Plastic Net Filter*/ Honeycomb Cooling Media:
WARNING: Switch the unit OFF and disconnect from the
electrical socket.
1.
Slide out the Plastic Net Filter* and clean with water.
2.
Remove all the screws from the Rear Grill of the Air Cooler.
3.
Carefully pull out the rear grill from the cooler.
4.
Carefully pull out the Honeycomb Cooling Media from the rear
grill.
5.
There are two Horizontal Bars holding the Honeycomb Cooling
Media in place. Remove all the screws from the Horizontal Bars
and then pull the bars off of the Honeycomb Cooling Media.
6.
Replace or clean media with water and a damp cloth as
needed.
WARNING: DO NOT operate the Air Cooler when the
Rear Grill or Honeycomb Media is removed from the Air Cooler,
or if there is a loose-fitting Rear Grill or Honeycomb Cooling
Media. Doing so can cause serious injury or dangerous
electrical shock.
*Applicable for models with Plastic Net Filter only.
EN
5
Plastic
Net
Filter
Honeycomb
Horizontal Bar
Cooling Media
Screws
Rear Grill
Screws
Tabla de contenido
