OK. OPD 700D Manual De Instrucciones página 18

EN
INSTALLING / REPLACING REMOTE CONTROL BATTERY
Push in direction of arrow and slide the battery holder out.
1
2 Insert 1x battery (type CR2025, 3 V
correct as indicated.
CHARGING BATTERY
Set the ON/OFF switch to the OFF position.
3
Plug the power adapter into the
4
DC IN 9-12V socket.
5 Connect the power adapter to a suitable
electrical outlet or...
6 ... connect 12 V car adapter to vehicle's 12 V
cigarette lighter socket.
This product can be powered by 12 V only.
DO NOT connect to vehicles with 24 V circuit.
CONNECTING MONITOR 2
7 Use the provided AV/Power cable to connect monitor 2 to monitor 1.
A. Monitor 1 AV OUT – Monitor 2 AV IN
B. Monitor 1 DC OUT – Monitor 2 DC IN
Note: Both monitor 1 and monitor 2 can be also used to display A/V signals from external
appliances via AV IN socket.
CONNECTING HEADPHONES
8 Connect provided earphones to the headphone jack of either monitor 1, monitor 2, or both.
ADJUSTING VOLUME
9 Set desired volume on either monitor or on the remote control using VOL+ and VOL- buttons.
DISC PLAYBACK
Set the ON/OFF switch to the ON position.
10
Slide the OPEN switch to open the disc compartment and insert a compatible disk
11
(DVD, VCD, or CD).
12 Close disc compartment. Playback starts (in most cases) automatically.
Note – If the playback does not start automatically: Press SOURCE button and choose DVD mode. Confirm
with ENTER. If no disc is inserted, the display shows NO DISC.
Use the navigation buttons
OPD700D_A5_140328 (1.2).indb 18
18
) in the battery compartment. Make sure the polarity is
During charging:
Charging indicator lights up red.
After charging (battery full):
Charging indicator lights up green.
Note: Charge the battery at least 4 hours before
using the appliance for the first time.
When built-in battery power is low: Low Battery
message appears on the screen.
to select the desired menu item and press ENTER to confirm.
28/3/14 8:08 PM