Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning
parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick
grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
8
MAINTENANCE
Remove the safety key and battery pack from the
machine before maintenance.
Keep the engine and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
8.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use
water.
8.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
WARNING
WARNING
English
2. Make sure that the blades fully stop.
3. Remove the battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw and spacers with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised
points engage the holes in the blade.
9. Put in the mounting screw and spacers and tighten
them.
8.3
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service
center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the
machine.
9
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
10
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the knobs
and bolts are
aligned correctly.
The battery ca-
Charge the bat-
pacity is low.
tery pack.
The bail switch is
Replace the bail
defective.
switch.
The lawn is
Examine the
rough.
mowing area.
The blade height
Move the wheels
is not set cor-
to a higher posi-
rectly.
tion.
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
Capítulos
Tabla de contenido
Solución de problemas
