Puky PUKYLINO Manual De Instrucciones página 8

PUKYLINO & WUTSCH PUKYLINO & WUTSCH
PUKYLINO scope of delivery (Figure A1):
®
1. Frame incl. rear axle, wheels
2. Steer tube incl. front axle, wheels
3. Handlebar
4. Seat
WUTSCH scope delivery (Figure A2):
®
1. Frame incl. rear axle, wheels
2. Steer tube incl. front axle, wheels
3. Handlebar
4. Seat
Assembly
The assembly instructions can be found on the
last pages of this manual.
You require the following tools for assem-
bly (Figure B):
1. Open-jawed spanner 10 mm
2. Allen key 5 mm
Small parts which are required during assem-
bly (e.g. screws and washers) must be kept
out of the reach of small children. There is a
danger of suffocation as a result of swallowing
the parts. Also keep all packaging material out
of reach of children.
The bike must be assembled with great cau-
tion and by an adult to avoid any potential sub-
sequent accidents or injuries. Please take a
sufficient amount of time to assemble the bike.
Several assembly steps require manual skill
and practice in handling tools (e.g. spanner).
Please contact your dealer or a workshop if
you have any questions.
In some cases, it is necessary to tighten
screws with a prescribed torque. This torque
value is stated in Newtons (e.g. 2 Nm). If the
torque with which a screw is tightened is too
low, the connection may still be too loose and
therefore unsafe. If the torque is too high,
screws and other parts may be damaged or
destroyed.
Figure 1: Remove the washer (!) from the
transportation lock by loosening the screw
connection.
Figure 2: Slide the steering tube onto the fork
shaft, until it reaches the stop. Make sure that
the steering head is aligned correctly (!) Add
the washer.
Figure 3: Slide the handlebar all the way onto
the fork shaft, and tighten the screw. Align the
slot in the handlebar with the rear (!) Firmly
press down on the spherical cap until it snaps
into position.
Figure 4: Attach the seat to the frame and
screw on.
8