Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12.5.3
Shelves
Storrage depending on kind of bottle and size. You can remove each shelf to store larger
bottles. To remove a shelf: Remove all bottles from the shelves. Lift the shelf upwards and
the gently pull it out, (eventually untighten the screws).
usual shelf
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Spread your bottles out as evenly as possible over the shelves, so weight is not
concentrated in one point; and make sure your bottles will not touch the back of the
cabinet.
12.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
This device is not designed to be installed in an RV or used with an inverter.
The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
13 Design and Function
This chapter provides you with important safety notices on the design and function of the
device.
bottom shelf
Please note
top shelf
30
Tabla de contenido
