Dremel 6700 Instrucciones De Funcionamiento Y Seguridad página 3

DM 1619PA7491_06-14_6700 6/26/14 11:46 AM Page 3
"READ ALL INSTRUCTIONS" — Failure to follow the SAFETY RULES
W RNING
identified by BULLET (•) symbol listed BELOW and other safety precautions,
may result in serious personal injury.
• Do not stand on tool or its stand. Serious
injury may occur if the tool is tipped or if the
cutting tool is accidentally contacted. Do not
store materials on or near the tool such that it
is necessary to stand on the tool or its stand
to reach them.
• Use safety equipment. Always wear
safety goggles. Dust mask, safety shoes,
hard hat or hearing protection must be used
for appropriate conditions. Everyday
eyeglasses only have impact resistant lenses,
they are NOT safety glasses.
Tool Use and Care
• Do not force tool. Use the correct tool for
your application. The correct tool will do the
job better and safer at the rate for which it is
designed. Do not use the tool for purpose not
intended - for example; do not use the miter
saw for slicing meats.
• Direction of feed — Feed work into a blade
or cutter against the direction of rotation of
the blade or cutter only.
• Do not use tool if switch does not turn it
"ON" or "Off". Any tool that cannot be
controlled with the switch is dangerous.
• Disconnect the plug from the power
source before making any adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally.
• Keep cutting tools sharp and clean.
Properly maintained tools, with sharp cutting
edges, are less likely to bind and easier to
control. When mounting saw blades be
certain that the arrow on the blade matches
the direction of the arrow marked on the tool
and that the teeth are also pointing in the
same direction.
Safety
• Inspect guards before using a tool. Keep
• Do not alter or misuse tool. Any alteration
• The use of any other accessories not
• Tool service must be performed only by
• When servicing a tool, use only identical
"SAVE THESE INSTRUCTIONS"
3
guards in place. Check moving parts for
binding or any other condition that may
affect the normal operation or safety
features of the tool. If damaged, have tool
serviced before using the tool. Many
accidents are caused by poorly maintained
tools.
or modification is a misuse and may result in
serious personal injury.
specified in this manual may create a
hazard. Accessories that may be suitable for
one type of tool, may become hazardous
when used on an inappropriate tool.
Service
qualified repair personnel. Service or
maintenance performed by unqualified
personnel may result in misplacing internal
wires and components which could cause
serious hazard.
replacement parts. follow instructions in
the Maintenance section of this manual.
Use of unauthorized parts or failure to follow
Maintenance Instructions may create a
hazard.