Remove The Blade; Operation; Start The Machine; Stop The Machine - GreenWorks CRD401 Manual Del Operador

1. Use the lower guard lever to lift the lower guard and hold
the lever.
2. Install the new blade.
3. Put the outer flange and the blade bolt on the spindle.
4. Push the spindle lock button to lock the spindle.
5. Use the hex key to tighten the bolt clockwise.
The arrow on the blade points the same direction as the
arrow on the top guard.
9.5

REMOVE THE BLADE

1. Push the spindle lock button to lock the spindle.
2. Use the hex key to loosen the blade bolt
counterclockwise.
3. Remove the bolt and outer flange.
4. Use the lower guard lever to lift the lower guard and hold
the lever.
5. Remove the blade.
10

OPERATION

WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
NOTE
2
3
1
3
English
10.1

START THE MACHINE

The machine can not work until the lock-off Button is
pushed fully to the left or right. Do not operate the machine
at low speeds for extended periods of time.
1. Pull the trigger to turn the machine ON.
10.2

STOP THE MACHINE

1. Release the trigger to turn the machine OFF.
Release the trigger and allow the machine to come to a
complete stop.
10.3

CUTTING ANGLE

1. Loosen the bevel lock knob.
2. Use bevel scale to set the necessary angle.
3. Tighten the bevel lock knob.
10.4

CUTTING DEPTH

1. Loosen the depth adjustment knob.
2. Raise or lower the base until the depth scale reaches the
required cutting depth.
3. Tighten the depth adjustment knob.
9
NOTE
WARNING
EN