Maintenance And Troubleshooting - Monosem CS 30 Instrucciones De Uso

4 . MAINTENANCE AND TROUBLESHOOTING

Your sowing control console is above all an electronic device, which needs to be treated with care. When sowing is
completed, it must be stored in a dry place.
If the cells are dirty, they should be cleaned with a soft brush.
Symptoms
The console does not
switch on.
ac of rains alarm
on one row.
ac of fertili er on a
row alarm.
No forward speed
alarm.
or in speed too
high alarm.
Disconnect the console power supply before performing any welding operation on the tractor or the seeder to
prevent the system from being damaged.
Probable cause
-The fuse on the console supply
harness has blown.
-Bad battery connection.
-Battery voltage too low.
-Battery polarity reversed.
-Faulty console.
-The number of rows programmed
exceeds the number of rows on
the seeder.
-The grain hopper is empty.
-The seeder element sensor is
dirty.
-Faulty sensor or harness.
-The number of fertilizer rows
programmed exceeds the number
of fertilizer sensors on the seeder.
e fertili er does not o in t e
dispensing hoses.
-Faulty sensor or harness.
-Faulty speed sensor
-Faulty console
- A limit speed not
be exceeded has
programmed in the advanced
menu padloc and
current or in speed
exceeds this limit speed.
ec t e fuse f lo n, replace it
fuse.
f it lo s a ain, c ec t at t e arness is neit er cut nor dama ed,
otherwise call our after-sales department.
ec t at t e lu s are clean and crimped properl
ec t at t e atter volta e is at least
recharge or replace the battery.
-Connect the wires to the battery properly.
-Contact our after-sales department.
-Program a number of rows equal to the number of rows of the
seeder on the CS30.
-Fill the hopper of the seeder element concerned with grains.
lean t e sensor it a e i le rus
-Swap the connection of the faulty sensor with a neighbouring
functional sensor and c ec
or not. If the problem has been displaced, the sensor is faulty.
t er ise, c ec t at t e arness is not dama ed
- Program a number of fertilizer sensors equal to the number of
fertilizer sensors of the seeder on the CS30.
ec t at t e fertili er tan is not empt and t e oses concerned
are not clogged.
-Swap the connection of the faulty sensor with a neighbouring
functional sensor and c ec
or not. If the problem has been displaced, the sensor is faulty.
t er ise, c ec t at t e arness is not dama ed
- No speed signal arrives at the console although at least one
sensor detects rains passin
wiring
- Contact our after-sales department.
to - Contact our after-sales department to modify or remove the limit
speed programmed.
been
t e
CAUTION
59
Solution
a ne five mpere
volts
et er t e pro lem is displaced
et er t e pro lem is displaced
ec t e speed sensor and its
t er ise,