Technical Data - Hercules KSZ 2100 Manual De Instrucciones

Anleitung_KSZ_2100_SPK7:_

5. Technical data

Asynchronous motor
Output
Operating mode
Idle speed n
0
Carbide-tipped saw blade
Number of teeth
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Weight
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Vibration emission value a ≤ 2,5 m/s
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
21.07.2010 15:14 Uhr
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
230 V~ 50 Hz
Adapt your working style to suit the appliance.
1700 W
Do not overload the appliance.
S1 Have the appliance serviced whenever
necessary.
4800 min -1
Switch the appliance off when it is not in use.
ø 210 x ø 30 x 2,8 mm
24
Residual risks
-45° / 0° / +45° Even if you use this electric power tool in
accordance with instructions, certain residual
0° to 45° to the left
risks cannot be rules out. The following hazards
205 x 65 mm
may arise in connection with the equipment's
140 x 65 mm
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
140 x 40 mm
2. Damage to hearing if no suitable ear protection is
13,3 kg
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
6. Before putting the machine into
Idle speed
operation
86 dB(A)
The machine must be firmly mounted in working
3 dB
position, e.g. on a workbench, the base frame
99 dB(A)
supplied with the machine, or similar.
3 dB
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
2
that the saw blade is correctly fitted and that the
machineʼs moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
7.1 Setting up the saw unit (Fig. 1/2)
To adjust the turntable (8), loosen the locking
handle (10) by approx. 2 turns, which frees the
turntable (8).
Turn the turntable (8) and scale pointer (11) to
the desired angular setting on the dial (12) and
lock into place with the locking handle (10).
Lightly press the machine head (4) down while at
Seite 11
GB
11