Preparing The Tool For Use; Inserting The Battery; Removing The Battery; Charging The Battery - Hilti BX 3-BT Manual De Instrucciones

Ocultar thumbs Ver también para BX 3-BT:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4.2
Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5

Preparing the tool for use

5.1

Inserting the battery

CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.2

Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.3

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.4

Removing the fastener guide

1. Switch off the fastening tool.
2. Remove the battery.
3. Remove the threaded stud from the fastener guide.
4. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
➥ The fastener guide will be released.
5. Remove the fastener guide.
5.5
Inserting the fastener guide
1. Switch off the fastening tool.
2. Remove the battery.
3. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
4. Slide the fastener guide into the nosepiece until it engages with an audible click.
Check that the black protective cap on the fastener guide is in full working order. Replace the
black protective cap if it is not in full working order.
5. Release the fastener guide locking catch.
➥ The fastener guide locking catch jumps to the middle position.
6. Grip and pull the fastener guide to check that it is securely seated.
8
English
Printed: 20.09.2019 | Doc-Nr: PUB / 5514235 / 000 / 00
4
21.6 V
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
2209577
*2209577*
Tabla de contenido
loading

Tabla de contenido