Lamp Adjustment - Futurelight Spotlite MH-860 Manual Del Usuario

To insert the lamp OSRAM HSR 575/2 95 V/575 W GX-9,5 or PHILIPS MSR 575/2 95 V/575 W GX-9,5,
MSD 575 95 V/575 W GX-9,5 open the small cover at the head's rearpanel (see the drawing) by loosening
the 3 Phillips screws X, Y and Z on the cover.
Gently pull out the lamp assemby.
If changing the lamp, remove the old lamp from the socket. Insert the lamp to the socket.
Do not install a lamp with a higher wattage! A lamp like this generates temperatures the device is not
designed for.
Damages caused by non-observance are not subject to warranty. Please follow the lamp manufacturer's
notes!
Do not touch the glass-bulb bare-handed during the installation! Make sure that the lamp is installed tightly
into the lampholder system.
Reinsert the lamp assembly and tighten the 3 screws again.
Before striking the lamp, reset the "LAti" counter in the main menu of the Control Board, by pressing the
"Up" and "Down" buttons in one time and then confirming with the Enter-button.
Do not operate the fixture with opened housing-cover!

Lamp adjustment

Remove the screws X, Y and Z for re-lamping
X
WARNING!
Disconnect the fixture from AC power before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min. before opening the covers
and removing lamp from the fixture.
B
Maximum room temperature t=40°C
Minimum distance from flammable material d=0,5m.
Exterior surface temperature T=80°C.
Not for domestic use.
Z
Adjust lamp position by turning screws A, B and C
The lampholder is aligned at the factory. Due to differences between lamps, fine adjustment may improve
light performance.
Strike the lamp, open the shutter and the iris, set the dimmer intensity onto 100 % and focus the light on a
flat surface (wall). Center the hot-spot (the brightest part of the beam) using the 3 adjustment screws "A, B,
C". Turn one screw at a time to drag the hot-spot diagonally across the projected image. If you cannot detect
a hot-spot, adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning all three screws "A, B, C" clockwise ¼-turn at a time until
the light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back
in the reflector. "Push" the lamp out by turning the screws "A, B, C" counterclockwise ¼-turn at a time the
light is bright and evenly distributed.
Screws
X, Y and Z
A
Y
Screws A, B and C
C
34
Remove the screws X, Y and Z for re-lamping
X
WARNING!
Disconnect the fixture from AC power before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min. before opening the covers
and removing lamp from the fixture.
B
Maximum room temperature t=40°C
Minimum distance from flammable material d=0,5m.
Exterior surface temperature T=80°C.
Not for domestic use.
Z
Adjust lamp position by turning screws A, B and C
A
Y
C