Every Six (6) Months (Or Once Every Pool Season Whichever Is Shorter); Nature 2 Mineral Cartridge Replacement; Important; Electrolytic Cell Cleaning - As Needed - Nature2 Fusion soft Serie Manual De Instalación Y Operación

6.4

Every Six (6) Months (Or once every pool season whichever is shorter)

6.4.1 Nature Mineral Cartridge Replacement
2
The Nature 2 cartridge for the Nature
shorter length of time).
1. Shut off the pool pump and fi lter.
2. Close valves between fi lter and pool to prevent pool draining.
3. Turn large collar counterclockwise to remove and lift off cap.
4. Remove old cartridge and discard in household trash. Insert the new cartridge (see Section 4.3)
5. Position cap fl at on the vessel housing.

IMPORTANT

Make sure the o-ring is secure in the groove on the vessel top, not on the underside of the
cap. Turn large collar clockwise until it locks into place, do not over tighten.
6. Open any valves that were closed to isolate the Nature
6.5

Electrolytic Cell Cleaning - As Needed

Depending upon water chemistry, occasional manual cell cleaning may be necessary.
1. Switch off the fi lter pump and chlorinator, close necessary valves.
Always turn pump off prior to installing or removing any components from the pool's plumbing. Your pump/fi lter
system is operated under pressure and pressure must be released before you begin to avoid system damage or
personal injury. Open the air relief valve on your pool fi lter to release the pressure in the system.
2. Unplug the yellow connector from the vessel.
3. Unscrew the electrolytic cell retaining ring and remove the electrolytic cell.
4. Look down into the electrolytic cell to see if there is scale on the plates.
To avoid personal injury when working with pool chemicals, always wear rubber gloves and eye protection, cover
exposed skin, and work in a well ventilated area. Use caution when choosing a location to open and use chemicals
as they may damage any surface into which they come in contact. If any chemical gets on your skin, rinse the area
immediately with water. If any chemical gets on your clothing, immediately remove the piece of clothing and rinse
with water.
5. Mix cleaning solution in a suitable plastic container by adding one (1) part of hydrochloric (muriatic) acid to
ten (10) parts water. Note: To avoid splash, always ADD MURIATIC ACID TO WATER rather than water to
muriatic acid. Solutions stronger than 1:10 will damage the electrolytic cell and void warranty. Submerge only
the plates of the electrolytic cell in the cleaning solution. See Figure 19. Allow the cleaning solution to dissolve
the calcium deposits for approximately fi ve (5) minutes.
6. Repeat the procedure if necessary. Take care to avoid splashing the electrolytic cell terminals and other
equipment with the acidic cleaning solution. Wash down any spills with plenty of fresh water. To neutralize acid
cleaning solution, add baking soda (foaming will occur).
7. Rinse the electrolytic cell in clean water and reinstall into the vessel. Insure the O-ring is seated properly and
coated lightly with silicone lubricant. Hand tighten collar.
Nature Fusion Soft Installation and Operation Manual
2®
2 Soft Fusion lasts six (6) months or one pool season (whichever is the
Fusion.
2
WARNING
WARNING
Page 39