Section 5. Operating Instructions; User Interface Controls; Figure 18. User Interface - Nature2 Fusion soft Serie Manual De Instalación Y Operación

Page 32
Section 5. Operating Instructions
NOTE The user interface is located inside the control/power center. To access the control panel, open the door to the
control/power center. See Figure 18.
Figure 18. User Interface
5.1

User Interface Controls

Chlorine
Production Rate
Adjustment
Salinity
Boost
Temperature
Nature Fusion Soft Installation and Operation Manual
2®
Pressing the down arrow button A or the up arrow button B will change the CHLORINE
PRODUCTION RATE in 5% increments. Generally, adjustments to production should be
made in 10% increments.
In the PureLink system, adjustments to the chlorine production rate can be made from
TM
either the AquaLink ® RS control panel or from the power center user interface.
Press the SALINITY button C to check the salinity of the water in pool.
Press and hold the POOL TEMP -BOOST- button D for 10 seconds to enter the Boost
mode (Note 'bo' will fl ash intermittently). Boost can be used to set chlorine production
to maximum (100%) for 24 hours of operation. After 24 hours of chlorinator run time,
chlorine production will return to previous setting. To clear the Boost mode, press and hold
the POOL TEMP -BOOST- button D again for 10 seconds.
NOTE When a pool pump timer is used to limit chlorinator run time, the 24 hours will only
count down when the chlorinator is on.
Press the POOL TEMP -BOOST- button D to check the pool water temperature.
Temperature measurements can be displayed in either Fahrenheit or Celsius. For more
information, see Section 8, Temperature Conversion.