Section 3. Installation Instructions; For Your Safety; Materials And Tools; Installation Requirements - Nature2 Fusion soft Serie Manual De Instalación Y Operación

Page 10
Section 3. Installation Instructions
FOR YOUR SAFETY: This product must be installed and serviced by a professional pool/spa service technician
as described on the front cover of this manual. The procedures in this manual must be followed exactly. Failure
to follow warning notices and instructions may result in property damage, serious injury, or death. Improper
installation and/or operation will void the warranty.
When using electrical products, basic precautions should always be followed, including the following:
• RISK OF ELECTRIC SHOCK WHICH CAN RESULT IN SERIOUS INJURY OR DEATH. Before attempting
installation or service, ensure that all power to the device is disconnected/turned off at the circuit breaker.
• Grounding is required. The unit should be installed by a qualifi ed service representative and should be properly
grounded and bonded. (See Section 3.8, Grounding and Bonding).
• Install to permit access for servicing.
• Read Section 1, Safety Information. Before attempting any electrical wiring, be sure to read and follow
Safety Instructions. Wiring should only be attempted by a qualifi ed professional.
3.1

Materials and Tools

NOTE Salt not included. See Section 4, Pool Water Preparation.
Installation Materials Furnished Needed
Nature Fusion Soft
2
Vessel with 2"-2½" (5 - 6.3 cm) Universal Unions
Sensor with 16 ft (4.88 m) Cable and O-ring
Universal Union Nut (to secure sensor)
16 ft (4.88 m) DC Power Cord
Installation and Operation with Warranty Information
FUSIONM or APUREM Power Pack (Sold separately)
Power Pack Housing with User Interface Control
Two (2) Wire Nuts
Installation Template
3.2

Installation Requirements

Decide where to install the Nature
• The vessel must be installed on a 17" (43 cm) length of pipe.
• The vessel must be installed on the existing pad or a concrete slab to support the weight.
• The vessel must be installed as the last piece of equipment in the circulation plumbing system just before the pool
with the Nature side as the inlet and the salt chlorinator side as the outlet. The inlet and outlet are clearly marked
2
on the vessel.
Nature Fusion Soft Installation and Operation Manual
2®
2 Fusion Soft.
WARNING
WARNING
PureLink with Power Center (Optional - Sold separately)
TM
AquaLink RS PureLink power center (Standard or Breaker)
®
Two (2) Wire Nuts
Installation Template
Tools Needed for Installation
Tape Measure
Phillips & Flathead Screwdrivers
Pliers
Hacksaw
Voltmeter to determine line voltage of AC wiring to power
supply
Electric Drill Motor and 1/4" (0.6 cm) masonry drill bit for
mounting power supply on block or stucco wall
An NSF approved All Purpose Cleaner Primer
®
An NSF approved All Purpose Cement (such as Weld-On 794,
793)