Split-Return Installation; Figure 6. Nature 2 Fusion Soft Split-Return Installation - Nature2 Fusion soft Serie Manual De Instalación Y Operación

3.6

Split-Return Installation

If the vessel is used with a water feature line system, it must be installed in a split-return confi guration or vessel
damage may occur.
1. Make sure the pool pump is turned off.
2. Remove the temporary cap on the cartridge side of the vessel, and install the Nature
in the box. Do not throw out the cap. It will be used for winterization of the system.
3. Locate a suitable section of pipe to install the vessel that conforms to the installation requirements outlined in
Section 3.2.
4. Install a 3-way valve in the return line to allow water to be diverted/restricted to the Nature
water feature line.
5. Fully open any closed valves, including the 3-way, to allow unrestricted fl ow to the Nature
water feature line.
6. Hand tighten all unions, sensors, and collars.
Be careful not to get fi nger caught between inlet union and plug when tightening as this may cause an injury.
Nature 2 Fusion Soft
Flow
Figure 6. Nature Fusion Soft Split-Return Installation
2
Nature Fusion Soft Installation and Operation Manual
2®
Heater
Flow/Temperature/
Salinity Sensor
Flow
Flow/Temperature/
Salinity Sensor
Pool Return
CAUTION
Optional ChemLink or
other ORP Control
Water Feature Line
Spa Return
2
start-up cartridge included
Fusion Soft and
2
Fusion Soft and
2
FUSIONM
or
APUREM
or
PureLink TM
or
Existing AquaPure
®
Power Pac k
Pump
Filter
Pool Intake Spa Intake
Page 15