Ice Machine Heat Of Rejection; Removing Drain Plug And Leveling The Ice Storage Bin - Koolaire K Serie Manual De Instalación, Operación Y Mantenimiento

Installation

Ice Machine Heat of Rejection

Series
Ice Machine
Conditioning
K0300
K0400
K0420
K0500
K0700
K1000 60hz
K1000 50hz
K1700
1 B.T.U./Hour
2 Because the heat of rejection varies during the
ice making cycle, the figure shown is an average.
Ice machines, like other refrigeration
equipment, reject heat through the
condenser. It is helpful to know the amount
of heat rejected by the ice machine when
sizing air conditioning equipment where
self-contained air-cooled ice machines are
installed.
This information is also necessary when
evaluating the benefits of using water-
cooled or remote condensers to reduce
air conditioning loads. The amount of heat
added to an air conditioned environment
by an ice machine using a water-cooled or
remote condenser is negligible.
Knowing the amount of heat rejected is
also important when sizing a cooling tower
for a water-cooled condenser. Use the peak
figure for sizing the cooling tower.
12
1
Heat of Rejection
Air
Peak
2
4600 5450
3800 6000
5400 6300
5300 6100
12400 13700
15400 17100
14600 16200
24700 29000
Removing Drain Plug and Leveling
the Ice Storage Bin
To avoid instability, the bin/dispenser
must be installed in an area capable
of supporting the weight of the bin/
dispenser, ice machine and a full bin of ice
(48" models 1000 lbs [454 kg], 30" models
750 lbs [340 kg]). The bin/dispenser must
be level side-to-side and front-to-back
before installing the ice machine.
1. Remove threaded plug from drain
fitting.
2. Screw the leveling legs onto the
bottom of the bin.
3. Screw the foot of each leg in as far as
possible.
Notice
The legs must be screwed in tightly to
prevent them from bending.
4. Move the bin into its final position.
5. Level the bin to assure that the bin
door closes and seals and the ice
machine operates properly. Use a level
on top of the bin. Turn the base of
each foot as necessary to level the bin.
6. Inspect bin gasket prior to ice machine
installation. (Our bins come with a
closed cell foam gasket installed along
the top surface of the bin.)
7. Remove all panels from ice machine
before lifting and installing on bin.
Remove front panel, top cover, left and
right side panels.
Part Number: 000014142 Rev 02 5/17
Section 2
Warning