Troubleshooting - OK. OPD 200 Manual De Instrucciones

en
MaIntenance
cleaning the main unit
Clean the outside of the unit with a clean soft cloth
moistened with luke-warm water. Do not use benzene,
thinner or alcohol, they may mar the finish of the
surface.

troublesHootInG

syMPtoM
no power or picture
no sound
Failed to play
Failed to respond to remote
control
Picture interferences
Failed to work with keys
44
warnInG: For your personal safety, be sure to
disconnect the AC power supply cord before
proceeding with any maintenance or cleaning action.
POSSIBlE CAUSE
Power supply cord is not correctly
conected with the main unit.
Power supply cord is not plugged into
an AC outlet.
the wrong input source is selected.
the input source fails to connect with
the tV.
Volume is set to minimum.
the MUtE button on the remote
control is pressed.
An incorrect sound system mode is
set.
the disc is incorrectly inserted.
Fingerprints or dust on the disc.
Obstacles placed between remote
control and unit.
Remote control outside control range.
Batteries in remote control are flat.
Interfering equipment is nearby the
player.
Dirt and scratches on the disc.
Unit might hang or have switched to
standby.
Power surges or other electrical
phenomena.
CORRECtIVE ACtIOn
Connect the power supply cord
with the main unit.
Plug the power supply cord into
an AC outlet.
Select the correct input source.
Check the connections.
turn up the volume by pressing
VOl +.
Press MUtE on the remote
control.
Set a correct sound system from
the main menu to match your tV.
Check the disc is properly
inserted.
Clean the disc.
Remove obstacles between
remote control and unit.
Aim remote control at the sensor
on the front panel.
Check batteries and replace them
if necessary.
Keep any kind of interfering
devices away from the player.
Clean or replace disc.
Shut down the unit, wait ten
seconds, and restart the unit.
Shut down the unit, wait ten
seconds, and restart the unit.