Radio Operation; Aux In Function; Tone Control - König Electronic HAV-TR800 Serie Manual De Uso

Mains operation
The device is designed for mains power supply AC 230 -240 V~50 Hz. Do not connect the device to
any other power supply to avoid damage that is not covered by your warranty.
1. Connect the connector to the AC socket at the rear of the device. Make sure that it is completely
inserted.
2. Insert the mains plug to a wall outlet.
3. Disconnect the power cord from the mains when not in use.
GENERAL OPERATING INSTRUCTIONS
Select the function 'Switch of radio' to 'RADIO' position.
On/off
Switch on the device by turning the volume control clockwise, until you overcome the point of
resistance. Switch off the device by turning the volume control counter-clockwise, until you overcome
the point of resistance.
Volume control
Increase or decrease the volume by rotating the volume control to the left or right.

RADIO OPERATION

Select with the FM, AM or AUX buttons to choose desired frequency band.
Advice for better reception
FM: Fully extend the telescopic antenna and position it for better reception.

AM: The device has a built-in antenna. Change the position of the device if reception is poor.

Frequency adjustment
Tune in the desired station by rotating the frequency scale. Rotating clockwise increases and

rotating counter-clockwise decreases the frequency.
The current adjusted frequency for selected band can be read on the frequency scale.


AUX in function

It can be used for listening music from any kind of audio reader device (MP3...etc.)
Connect a cable (double 3.5 mm jack - not included) between the audio reader and the line-in jack of
the radio (on the side of the radio).
Select the desired music. Adjust the volume with the radio volume control.
If you do not use the aux in function, take out the 3.5 mm aux plug from the radio and the unit and enter
to power management mode.

Tone control

Adjust the tone by rotating the tone knob. By rotating to the left the bass is intensified, rotating to the
right intensifies the treble.
GENERAL OPERATION FOR Bluetooth
1. Place the radio and device where they are no more than 10 meters apart.
2. Select the radio Function switch to Bluetooth
Select FM or AM with the FM/AUX/AM select button.
3. Activate the Bluetooth
4. While searching for the device, the radio LED indicator flashes.
5. Wait until 'DR70BT' appears in the list of your Bluetooth
6. Select 'DR70BT'.
®
7. When Bluetooth connection is made, the radio LED indicator is on.
8. Press the play/pause button for playing or pausing the music.
9. Press the track buttons to select tracks.
10. Adjust the volume & tone control located on the top of the radio for desired volume level and
high-low tone level.
®
WIRELESS TECHNOLOGY
®
position.
®
function of the device and set it to search for Bluetooth
5
®
-enabled devices.
®
device.