Makita GS5000 Manual De Instrucciones página 7

Tool with the outer flange (convex type)
3
1
2
013671
Tool with the outer flange (flat type)
3
1
2
013672
Securing method for tool with the both types outer
flanges
1
2
4
013670
Insert screwdriver into the hole in the inner flange. Grip
the hex nut with the wrench, turning in the direction of
wheel rotation to loosen the hex nut. Remove the hex
nut and outer flange. Then install the wheel, outer
flange and hex nut.
Tighten the hex nut in the direction of arrow as shown in
the figure.
1. Hex nut
4
2. Outer flange
(convex type)
3. Grinding wheel
4. Spindle
1. Hex nut
4
2. Outer flange
(flat type)
3. Grinding wheel
4. Spindle
1. Screwdriver
2. Hex wrench
3. Inner flange
4. Hex nut
3
OPERATION
CAUTION:
Apply light pressure on the tool. Excessive
•
pressure on the tool will only cause a poor finish
and overloading of the motor.
The grinding wheel continues to rotate after the
•
tool is switched off.
Hold the tool firmly with one hand on the switch
•
handle and the other hand on the front grip when
performing the tool.
013600
Hanger (optional accessory)
013599
Continuous operation of the grinder is made easy by
using the handy hanger as shown in the figure. Simply
loop the cord over the head or shoulder, after threading
it through the eyelet on the top of the tool housing.
7