Breezy RelaX2 Manual De Usuario página 5

recommend that users over 100 kg in weight are not transferred in
this way.In general, any anti-tip tubes fitted must be set before-
hand, sothat they cannot touch the steps, as otherwise this could
lead to aserious tumble. Afterwards the anti-tip tubes must be set
back totheir correct position.
Danger!
Make sure that the attendant only holds the wheelchair using
securely mounted parts. Do not use removable parts (e.g. not on
the footrests or the sideguards).
Danger!
When using the lifting ramp make sure that the anti-tip tubes fitted
are positioned outside the danger area.
Danger!
Secure your wheelchair on uneven ground or when transferring
(e.g.)into a car) by using the brakes.
Danger!
If and whenever possible, during a journey in a specially fitted
vehicle for disabled people, vehicle occupants should use the
seats in the vehicle and the appropriate restraint system. This is
the only way to ensure that occupants will have the maximum pro-
tection if there is an accident. When using safety elements offered
by SUNRISE MEDICAL and using a specially designed safety
system, lightweight wheelchairs can be used as a seat when
being transported in a specially fitted vehicle. (See the Chapter on
"Transportation").
Danger!
Depending on the diameter and setting of the castors, as well as
the centre of gravity setting of the wheelchair, the castors may
begin to wobble at high speeds. This can lead to castor seizure
and the wheelchair may tip over. Therefore, please make sure that
the castors are adjusted correctly (see the Chapter "Castors").
In particular, do not travel on an incline without brakes, travel at
a reduced speed. We recommend that novice users use anti-tip
tubes.
Danger!
Anti-tip tubes should prevent the chair tipping over backwards
unintentionally. Under no circumstances should they take the
place of transit wheels, and be used to transport a person in a
wheelchair with the rear wheels removed.
Danger!
When reaching for objects (which are in front of, to the side or
behind the wheelchair) make sure that you do not lean too far out
of the wheelchair, as if you change the centre of gravity there is a
risk of tipping or rolling over. The hanging of additional load (back
pack or similar items) onto your chair back posts can affect the re-
arward stability of your chair, especially when used in combination
with recliner backrests. This can cause the chair to tip backwards
causing injury.
Danger!
For thigh amputees you must use anti-tip tubes.
Danger!
Before setting off, check that your tyre pressure is correct. For
rear wheels it should be at least 3.5 bar ( 350 kPa). The max.
pressure is indicated on the tyre.The knee-lever brakes will only
work if there is sufficient tyre pressure and if the correct setting
has been made (see the Chapter on "Brakes").
Danger!
If the seat and back sling are damaged, you must replace them
immediately.
Danger!
Be careful with fire, in particular with burning cigarettes. Seat and
back slings can be set alight.
Danger!
If the wheelchair is subject to direct sunlight / cold temperature
for a long period of time, then parts of the wheelchair (e.g. frame,
legrests, brakes and sideguard) may become hot (>41°C) / very
cold (<0°).
Danger!
Always make sure that the quick-release axles on the rear wheels
are set properly and lock in (locking ball bearings are showing
completely through the axle sleeve). If the button on the quick-
release axle
is not pressed in, the rear wheel cannot be removed.
Note !
The effect of the knee-lever brake as well as the general driving
characteristics are dependant on tyre pressure. The wheelchair
is significantly lighter and easier to manoeuvre when the rear
wheels are pumped up correctly and both wheels have the same
pressure.
Note !
Make sure that your tyres have sufficient tread!
Please note that you are subject to any and all traffic laws when
driving in public traffic.
Note !
Always be careful when handling or adjusting the wheelchair!
Note !
Adjustments which require tools should always be done by
authorized dealers.
The products shown and described in this manual may not be
exactly the same in every detail as your own model. However,
all instructions are still entirely relevant, irrespective of detai
differences.
The manufacturer reserves the right to alter without notice any
weights, measurements or other technical data shown in this
manual. All figures, measurements and capacities shown in this
manual are approximate and do not constitute specifications.
Lifetime
The expected lifetime of this product is 5 years provided that:
- it is used in strict accordance with the intended use
- all service and maintenance requirements are met.
5