Bresser TAURUS 90/900 NG Instrucciones De Uso página 10

General Information
About This Instruction Manual
Please read the safety instructions in this manual carefully. To avoid damage
to the unit and the risk of injury, only use this product as described in the
manual. Keep the instruction manual handy so that you can easily look up
information on all the functions of your telescope.
CAREFUL
You will find this symbol before every section of text that
deals with the risk of minor to severe injuries resulting from
improper use.
ATTENTION
You will find this symbol in front of every section of text
that deals with the risk of damage to property or the
environment.
Intended Use
This product is intended only for private use. It was developed for the magni-
fied display of things in nature.
General Warning
RISK OF BLINDNESS
Never use this device to look directly at the sun or in the direct prox-
imity of the sun. Doing so may result in a risk of blindness.
CHOKING HAZARD
Children should only use the device under adult supervision. Keep
packaging material, like plastic bags and rubber bands, out of the
reach of children, as they pose a choking hazard.
FIRE RISK
Do not place the device, particularly the lenses, in direct sunlight.
The concentration of light could cause a fire.
ATTENTION
Do not disassemble the device. In the event of a defect, please
contact your dealer. The dealer will contact the Service Centre and
can send the device in to be repaired, if necessary.
Do not expose the device to high temperatures.
Privacy Protection
This device is intended only for private use. Please heed
the privacy of other people. Do not use the device to look
into apartments, for example.
Accessories may vary depending on the model.
Parts (Fig. 1-3)
B
Telescope tube
C
LED Viewinder scope
D
Adjusting screws
E
Barrel opening
F
Objective
G
Eyepiece connection tube
H
Focus wheel
I
Tube rings
J
Tripod head
1)
Accessory tray
1! Adjusting screws (tripod)
1@
Fixation bracket (accessory tray)
1#
Tripod legs
1$
Flexible shaft (right ascension axis)
1%
Flexible shaft (declination axis)
1^
Tripod brace
1&
Incline plate
1*
Eyepieces
1(
Diagonal mirror
2)
Barlow Lens
2!
Smartphone holder
Parts (Fig. 15): Multi-Purpose Mount
A Vertical clamp
B Incline plate
C Declination axis
D Flexible shaft (right ascension axis)
E Flexible shaft (declination axis)
F Focus wheel
Part I — Set Up
1. General/Location
Before you begin construction, you must choose a suitable
location for your telescope.
It will help you, if you build this appliance in a place, where you have
a clear view of the skies, a stable footing and sufficient space around
you.
Remove all the parts from the packaging first. Check, using the dia-
gram, whether all the parts are there.
NOTE
Important: Only hand-tighten screws. Do not overtighten.
2. Tripod
The tripod legs are preinstalled and already connected to the tripod head (Fig.
1, 9) and tripod brace (Fig. 1, 16). Remove the tripod from its packaging and
place it upright, with the feet at the base. Take two of the legs and carefully
pull them apart until they are in the fully open position. The entire weight of the
tripod rests on one leg during this procedure. Then set the tripod upright
again.
Now extend each individual tripod leg to the desired length (Fig. 4) by loos-
ening the fastening clips (Fig. 4, X). Tighten the fastening clips to hold the
legs at the desired length, and place the tripod on a hard, flat surface.
i
HINT
A small spirit level placed on the accessory tray (Fig. 1,
10) may help you set up your telescope so that it's level.
- 10 -