Commissioning; Switching On/Off; Battery Pack; Mains Adapter - Festool ETSC 125 Li Manual De Instrucciones

[1-9] Handle (insulated gripping surface)
[1-10] Mains adapter with plug-it connec­
tion*
[1-11] Plug-it cable*
[1-12] Long-life dust bag
* not on all versions included in the scope of
delivery
The specified illustrations appear at the begin­
ning of the Operating Instructions.
6

Commissioning

6.1

Switching on/off

The switch [1-1] serves as an on/off switch (I =
ON, 0 = OFF).
When the battery pack is empty, or if
there is a power failure or the mains
plug is removed, move the on/off switch
immediately to the Off position. This pre­
vents uncontrolled restarting.
6.2

Battery pack

► Inserting the battery pack [2a]
► Removing the battery pack [2b]
Capacity display
Pressing the green button on the capacity dis­
play [1-3] shows the charge status of the bat­
tery pack:
70 - 100%
40 - 70%
15 - 40%
< 15%
Recommendation: Charge
battery pack before further
use.
6.3

Mains adapter

WARNING
Unauthorised voltage or frequency!
Risk of accident
► The mains voltage and the frequency of the
power source must correspond with the
specifications on the machine's name
plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
The mains adapter (available as an accessory
depending on the model) facilitates use of the
cordless sanding technology with mains power,
enabling you to switch between power supply
sources. The mains adapter enables the mobile
dust extractor's automatic electronic switch-
on/shut-off function.
For older mobile dust extractors, the au­
tomatic electronic switch-on/shut-off
may only be activated under load and not
yet under no-load speed due to low pow­
er consumption.
► Insert the mains adapter [3a]
► Connect the mains adapter and plug-it ca­
ble [3b]
► Remove the mains adapter [3c]
► Detach the mains adapter from the plug-it
cable [3d]
7

Settings

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
7.1 Electronics
Smooth start-up
The electronically controlled smooth start-up
function ensures that the power tool starts up
smoothly.
Temperature cut-out
To avoid the motor overheating, the power con­
sumption is limited at an excessive motor tem­
perature. If the temperature continues to rise,
the power tool switches off and can only be
switched on again once the motor has cooled
sufficiently.
Constant speed
The preselected motor speed is kept constant
through electronic control. This means that, if
the machine is used as intended (reasonable
contact pressure), a constant sanding speed is
achieved.
Setting and adjusting the speed
The speed can be set [1-6] between 6000 and
10000 min using the adjusting wheel.
-1
For sanding, we recommend the following set­
tings for the adjusting wheel [1-6]:
English
15