Important Safety Instructions - Makita AR410HR Manual De Instrucciones

ENGLISH (Original instructions)
1. Safety glasses
2. Face shield
3. Deep
4. Shallow
5. Sunk too deeply (turn to raising
side)
6. Appropriate
7. Raised too high (turn to sink side)
8. Hook
9. Screw
10. Knob
11. Lever
12. Magazine cap
13. Screw channel
14. Lead screw
SPECIFICATIONS
Screw capacity
Safety Device
Drive Adjustment
Screw Feed Mechanism
Min. hose diameter
Dimensions (L X H X W)
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. Wear safety glasses.
............. Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work in
2" x 4" housing.
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO
Explanation of general view
15. Feeding claw
16. Hammer
17. Bar
18. Screwdriver
19. Hex bolt
20. Hex wrench
21. Top cap
22. Top cap gasket
23. Top cap spacer
24. Piston assembly
25. Driver guide
26. Eyeleteer
27. Rubber ring (white)
28. Cutter knife
29. Pin
Model
Air pressure
Screw length
Net weight
REDUCE THE RISK OF PERSONAL INJURY,
INCLUDING THE FOLLOWING:
END106-2
READ ALL INSTRUCTIONS.
• For personal safety and proper operation and
maintenance of the tool, read this instruction manual
before using the tool.
• Always wear safety glasses to protect your eyes from
dust or screw injury.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
and by other persons in the immediate working area.
• For Australia and New Zealand only
ENE059-1
Always wear safety glasses and face shield to protect
your eyes from dust or screw injury. The safety glasses
and the face shield should conform with the
requirements of AS/NZS 1336.
WARNING:
It is an employer's responsibility to enforce the use of
safety eye protection equipment by the tool operators
ENB113-1
and by other persons in the immediate working area.
(Fig. 1)
30. Piston cap
31. Driver bit
32. Piston
33. New driver bit
34. Hollowed side
35. Holes
36. Rubber ring
37. Drain cock
38. Air filter
39. Oiler
40. Pneumatic oil
41. Thinner
42. Stove
AR410HR
1.76 - 2.26 MPa (17.6 - 22.6 bar)
Coil type 25 - 41 mm
Sheet-collated 100 pcs
Contact Arm System
Dial Type (Adjustment Range: 6mm)
Feed Piston System
5.0 mm
296 mm X 116 mm X 305 mm
2.0 kg
7