Safety Warnings - S&P HTB-2500 Manual De Instalacion Y Uso

3. SAFETY WARNINGS

WARNING: SOLER & PALAU Sistemas de Ventilación S.L.U. (S&P) shall not be held liable
for any damages to the machine and/or persons caused by failure to comply with the Safety
Warnings in this manual.
WARNING: It is very important to follow and respect all the safety warnings below. Failure to
do so may lead to personal injury and/or damage to the machine.
WARNING: Using the product in a way other than that described in this document shall be
considered inappropriate and, therefore, not safe. Unapproved uses may damage equipment
or cause personal injury. Any use other than that for which the product was designed and as
described in this document shall be considered non-compliant and as a result S&P shall not
be held liable.
• To ensure personnel operating the device are not exposed to any risks during the installa-
tion, maintenance or cleaning processes, they must use the following Personal protective
equipment (PPE):
SAFETY HELMET
PROTECTION
GLOVES
ANTI-FALL
MEDIA
NOTE: S&P shall not be held liable under any circumstances for damage to property and/or
individuals caused by improper installation, maintenance or cleaning.
• Given the weight of the device, it must be installed by at least two properly trained specialists.
• Large-diameter ceiling fans can be used when the temperature is between: 10°C – 45°C.
• It is completely prohibited to modify any of the parts that make up this product or replace
them with anything other than original S&P spare parts.
• Before installing the device, make sure all safety measures in Figure 1 will be respected.
• The ceiling or structure the device is attached to must be strong enough to hold 100 kg /
2
20 cm .
NOTE: S&P shall not be held liable under any circumstances for damage to personal pro-
perty and/or individuals caused by devices installed on drop ceilings, weak ceilings or other
spots with inadequate support.
• Large-diameter ceiling fans must be installed permanently. To connect them to the power
grid, the guidelines in the Low Voltage Directive or those that apply in the country in ques-
tion must be taken into account.
• Measures for multi-polar switch-off at the mains must be incorporated into the permanent
installation with at least 3 mm separation between all poles so the fan is fully disconnected
in category III overvoltage conditions.
PROTECTION
CLOTHING
SAFETY
GLASSES
13