Automatic Mode; Operation - cecotec CONGA 899 SLIM Manual De Instrucciones

• Before use, make sure the switch is on "I".
• If the robot has a pause of more than 10 minutes, it will turn off.
• To change the cleaning mode, read the section on "Mode options".
CHARGE
Place the cleaner on the charging base, make sure the charging poles are aligned.
STOP CLEANING
To stop the appliance, press the
control.

4. OPERATION

There are several cleaning modes, in order to adjust to different conditions, that offer a good
finish. The user can choose the most suitable mode on the remote control.

AUTOMATIC MODE:

It is the most frequent mode. The cleaner vacuums the floor automatically. If
there are any obstacles on its way, it changes direction.
Tips: put the machine near the area to be cleaned, press the Spot Cleaning
button on the remote control to enter this mode.
POINT CLEANING MODE: SPIRAL
The robot works in a spiral, focusing on a spot. When it finishes cleaning, it will
go back to the starting spot and stop Tips: the machine can automatically clean
the room while in this mode and adjust the cleaner's path according to several
ground environments.
EDGES CLEAN MODE
This mode can be used to vacuum the corners and walls. The robot runs along hard obstacles.
• button: Green/blue blinking light indicates the cleaner is
charging.
• button: Green/blue light indicates the cleaner is fully charged.
Charge the cleaner for 12 hours before the first use.
button on the control panel or the OK button on the remote
ENGLISH
CONGA 899 SLIM 21