Bartscher GE 25 Manual De Usario página 36

HOT STEAM! Danger of burn!
During taking the lid off there is a danger of burn by the
escaping steam and condensate! Be particularly careful
while doing this!

With the use of the temperature control it is possible to adjust the temperature
gradually from approx. 30

Set the temperature control at the desired temperature by turning it clockwise (the
green control light of heating will go on). When the desired temperature is reached,
the control light goes off.
NOTE!
The heat is created via a heating coil in the bottom part of the mulled wine pot/
preserving pot. The electric temperature control with the temperature sensor
are placed here as well. The adjustment of temperature is done via the
thermostat switch.
NOTE!
The heating time depends on the liquid and the amount. When the desired
liquid temperature is reached the thermostat shuts off automatically.
In case the liquid temperature drops below the desired temperature the
thermostat switches on to keep the liquid at the set temperature over a larger
period of time.

For tapping/drawing liquid turn the handle of the stop valve to the front. After
finishing the tapping of liquid turn back the stop valve to its original position.

Conditional on the system a quantity of approx. 1 litres remains in the container.
This quantity can be slightly reduced by carefully tilting the container forward.
HOT SURFACE! Burn hazard!
While operating the mulled wine pot the surface of the
container will be heated up according to the adjusted
temperature! Do not touch hot surface!

When the device is not in use, make sure you the temperature controller is turned all
the way to the left as far as it will go, pull the power plug out of the socket, let the
liquid drain and clean the container after it has cooled off.
- 32 -
° °
C - 100 C.