Connecting The Led Strip To The Receiver - Schluter LT ES 11 Manual De Uso

Establish a cable reserve by looping the cable at the start of the channel.

During the further mounting process, make sure that this cable loop is not impaired.

This ensures that the cable is strain-relieved when the LED strip is subsequently

removed from the profile.
Run the cable to the power pack.

Lay the cable to the power pack's 24 V terminals. Ensure the correct polarity while

doing so. Also read the directions for use for the power pack for this purpose.
Connecting several LED strips directly to a power pack
Pull the connection cable of the LED strips into cable channels or empty tubes as

described above.
Conduct the connection cables into an installation box.

Combine the wires of the connections of the LED strips to one LIPROTEC-ZKL terminal

connector having the same colour each. For each wire, use a single contact of the
terminal connector (see Fig. J).
Depending on the type of the terminal connector, you can connect two or four LED

strips.
Connect the terminal connectors to the power pack with an additional cable. For this

purpose, use a LIPROTEC LT ZK 2A cable. Make sure the correct polarity is observed
and the maximum permissible length of 10 m is not exceeded. For this purpose, read
the directions for use of the power pack as well.

6.4 Connecting the LED strip to the receiver

Connecting one or more LED strips to a receiver
Run the LED strip's connection cable to the incoming cable channel through the

mounting profile's borehole.
Create a cable reserve by looping the cable at the start of the channel. During the

further mounting process, make sure that this cable loop is not impaired.
This ensures that the cable is strain-relieved when the LED strip is subsequently

removed from the profile.
Run the LED strip's and the receiver's connection cables to an installation box.

Combine the colour-coded wires of the LED strips' and the receiver's connections on

one LIPROTEC ZKL terminal connector. For each wire, use a single terminal connector
contact (see Figs. H, I and J).
Depending on the terminal connector type, you can connect a maximum of two or

four LED strips.
Directions for use for LED strips
EN
Connection
33