Additional Safety Rules - Makita 9207SPB Manual De Instrucciones

ENGLISH
1 Side grip
2 Switch trigger
3 Lock button
4 Low
5 Speed change switch
6 High
7 Speed change knob
SPECIFICATIONS
Model
Max. capacities
Abrasive disc ................................................................................ 180 mm
Wool bonnet ................................................................................. 180 mm
-1
No load speed (min ) ................................................................ High: 3,800
Overall length .................................................................................. 455 mm
Net weight .......................................................................................... 3.4 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC supply.
They are double-insulated in accordance with Euro-
pean Standard and can, therefore, also be used from
sockets without earth wire.
Safety hints
For your own safety, please refer to the enclosed
safety instructions.

ADDITIONAL SAFETY RULES

1. Always use eye and ear protection. Other per-
sonal protective equipment such as dust mask,
gloves, helmet and apron should be worn when
necessary. If in doubt, wear the protective equip-
ment.
2. Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
3. Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels
and other accessories running over rated speed
can fly apart and cause injury.
4. Check the backing pad carefully for cracks, dam-
age or deformity before operation. Replace
cracked, damaged or deformed pad immediately.
5. Check that the workpiece is properly supported.
6. Hold the tool firmly.
7. Keep hands away from rotating parts.
8. Make sure abrasive disc or wool bonnet is not
contacting the workpiece before the switch is
turned on.
9. When sanding metal surfaces, watch out for fly-
ing sparks. Hold the tool so that sparks fly away
from you and other persons or flammable mate-
rials.
Explanation of general view
8 Arrow indication
9 Lock nut
10 Abrasive disc
11 Rubber pad
12 Spindle
13 Lock nut wrench
14 Loosen
10. Do not leave the tool running. Operate the tool
11. Pay attention that the wheel continues to rotate
12. Do not touch the workpiece immediately after
13. If working place is extremely hot and humid, or
14. Do not use the tool on any materials containing
15. Do not use water or grinding lubricant.
16. Ventilate your work area adequately when you
17. Always use the correct dust mask/respirator for
18. Ensure that ventilation openings are kept clear
ENB047-3
SAVE THESE INSTRUCTIONS.
15 Tighten
16 Wrench
17 Wool bonnet
18 Tie a bow knot
19 Limit mark
20 Screwdriver
21 Brush holder cap
9207SPB
Low: 2,000
only when hand-held.
after the tool is switched off.
operation; it may be extremely hot and could burn
your skin.
badly polluted by conductive dust, use a short-
circuit breaker (30 mA) to assure operator safety.
asbestos.
perform sanding operations.
the material and application you are working with.
when working in dusty conditions. If it should
become necessary to clear dust, first disconnect
the tool from the main supply (use non metallic
objects) and avoid damaging internal parts.
9217SPC
180 mm
180 mm
1,500 – 2,800
—
470 mm
3.5 kg
5