Working Information - Hitachi Koki ML 34SR Instrucciones De Manejo

Working information

Plug into mains
1. Connect the connector of the extension
lead conducting electricity to the switch/
connector combination (8).
2. Secure machine connecting cable with
cable strain relief (9).
The loop of the mains cable must be long
enough for the cable strain relief to slide
from one side to the other.
Switching on the motor (10)
Start the lawn mower only on level ground, and
not in high grass. The ground must be free from
foreign objects and body, such as stones. Do
not lift or tilt the lawn mower to start it.
1. Keep the start button pressed (10a).
2. Pull the safety bar toward the handle bar
and hold it there (10b).
3. Release the start button.
Switching off the motor
1. Release the safety bar.
2. Wait until the cutter blade stops.
Mulching with the mulching kit (only
ML40SR)
In the case of mulching, the cut grass is not
collected, but left on the lawn. The mulch
protects the ground against drying out and
provides it with nutrients.
The best results are obtained by cutting the
grass regularly to a height of approx. 2 cm. Only
young grass with soft leaf tissue rots quickly.
Grass height before mulching: max. 8 cm
Grass height after mulching: min. 4 cm
Adapt walking pace to the mulching; do
not walk too fast
Fitting the mulching kit
Danger - risk of injury!
Only fi t or remove the mulching kit with
the motor switched off and the blade
stationary.
1. Remove the grass catcher (4).
2. Lift the baffl e and insert the mulching kit into
the ejection channel (5).
The mulching kit must click into place
(6).
If the mulching kit does not click into
place, both the mulching kit and the
blade may be damaged
Removing the mulching kit
1. Lift the baffl e plate and release the lock on
the mulching kit (7a).
2. Pull out the mulching kit (7b).
WORKING INFORMATION
Observe the local regulations on
operating lawn mowers.
Keep others away from dangerous areas.
Use the mower only if visibility is good.
Guide the machine at walking pace.
Mow only with a sharp cutting blade.
Do not mow over obstacles (e.g. branches,
roots of trees).
On sloping terrain, always mow across the
slope. Do not mow uphill or downhill or on
slopes where the inclination exceeds 20o
Added care must be taken on slopes when
changing direction.
# Optimum operating time is obtained
by frequent mowing of the lawn and
maintaining a short-cut lawn.
Tips for mowing
Maintain a constant cutting height 3–5 cm;
do not shorten the grass to less than half its
original height.
Do not overload the lawn mower! If the
motor speed is greatly reduced due to long,
heavy grass, raise the cutting height and
mow several times.
Since wind and sun can dry out the lawn
after mowing, mow the lawn in the late
afternoon.
en
17