Assembly; Operation - Hitachi Koki ML 34SR Instrucciones De Manejo

en
Always push the mower forward, never
move backwards
Never pull the mower toward the body
Do not mow over obstacles (e.g. branches,
roots of trees).
Make sure the motor is stopped before you
remove any cuttings.
Never lift or carry the mower while the motor
is running
Never leave the mower unattended when it
is ready for operation
Unauthorized modifi cations may impair the
safety of your product and may result in
increased noise and vibration.
Regularly inspect the supply cables. Do
not connect damaged cables to the supply
or touch a damaged cable before it is
disconnected from the supply. A damaged
cable can lead to contact with live parts.
Beware electric shock hazard.
If the machine starts to vibrate abnormally,
remove the plug.
Never touch the plug with wet hands.

ASSEMBLY

Assemble according to enclosed assembly
instructions.
CAUTION!
The machine must not be put in
operation before it has been assembled
completely.

OPERATION

Adjusting the cutting height (1)
CAUTION!
Danger - risk of injury!
Adjust the cutting height only while
motor is switched off and the cutting
blade has stopped!
1. To unlock, press the lever to the side and
hold (1).
For a short lawn slide the lever in the
direction of the front wheel. Minimum
step 1: 2.8 cm
16
For a longer lawn slide the lever in the
direction of the rear wheel. Maximum
step 6: 6.8 cm
2. Release the lever and slide it forward or
backward until it engages in the desired
step.
Handle bar adjustment (2)
1. Keep the buttons on the handle bars
pressed (2a).
2. Adjust to the desired height (2b)
3. Release the buttons and engage the handle
bar.
Level indicator (3)
The level indicator is pressed upwards by the
air stream during mowing (3a). When the grass
catcher is full, the level indicator rests against
the catcher (3b). The grass catcher needs to be
emptied.
Attaching the grass catcher (4)
CAUTION!
Danger - risk of injury!
Remove or replace the grass catcher
only while the motor is switched off and
the cutting blade has stopped.
1. Lift up the baffl e plate (4a) and hang the
grass catcher into the holders. (4b)
Emptying the grass catcher (4)
1. Lift the baffl e plate. (4a)
2. Unhook the grass catcher and remove it to
the rear.
3. Empty grass catcher.
4. Lift up the baffl e plate and hang the grass
catcher back into the holders. (4b)
Assembly
ML 34SR / ML 40SR