Stihl MSE 170 C Manual De Instrucciones página 29

1
Fit the chain – start at the bar nose.
N
Pay attention to the position of the
tensioning gear and the cutting
edges.
Turn the tensioning gear (1)
N
clockwise as far as stop.
Turn the guide bar so that the
N
tensioning gear is facing you.
2
Fit the chain over the sprocket (2).
N
Push the guide bar over the bar
N
stud (3), the head of the rear bar
stud must engage the slot.
MSE 170 C, MSE 210 C
Make sure the drive link tangs
N
engage the bar groove (arrow) and
then rotate the tensioning gear
counterclockwise as far as stop.
Place the chain sprocket cover in
N
position and engage the guide lugs
in the recesses in the handle
housing.
3
When fitting the chain sprocket cover,
check that the teeth of the tensioning
gear and adjusting wheel mesh properly.
4
5
If necessary, turn the adjusting
N
wheel (4) slightly until the sprocket
cover can be pushed flush against
the handle housing.
Pull the hinged handle (5) out until it
N
engages in the upright position.
Fit the wingnut and tighten it
N
moderately – finally tighten the
wingnut by hand only after
tensioning the saw chain.
Go to chapter on "Tensioning the
N
Saw Chain"
English
27