Casa Lorente compakt 500E Manual De Instrucciones página 48

Tabla de contenido
c
t
v
u
o
!1
!0
b
n
t
m
!3
y
i
!2
!2
!2
!4
c Pull the buttonhole lever down as far as it will go.
t Buttonhole Lever
NOTE:
If you start the machine with the buttonhole lever not
lowered, the buttonhole lever sign blinks after sewing
several stitches.
y Buttonhole lever sign
v Insert the corner of the fabric under the foot.
Press the needle up/down position button twice.
Remove the fabric to the left to draw the needle thread
through the hole of the foot.
Place the garment under the foot, and lower the
needle at the starting point of the buttonhole mark.
Then lower the automatic buttonhole foot R.
u Buttonhole Mark
i Starting Point
NOTE:
Make sure there is no gap between the slider and
stopper, otherwise the left and right lengths will be
different.
o Slider
!0 Stopper
!1 No gap
!2 Sewing gap
b Start the machine to sew the buttonhole.
The buttonhole is sewn in the sequence as shown.
When the buttonhole is finished, the machine will stop
automatically with the needle in the up position.
To sew another buttonhole, raise the presser foot.
Move the fabric to where the next buttonhole is to be
sewn, then lower the foot and start the machine.
n When buttonhole sewing is finished, push the
buttonhole lever upward as far as it will go.
Buttonhole lever
t
m Remove the fabric and place a pin just below the
bartack at each end to prevent accidentally cutting
stitches.
Cut the opening with the seam ripper.
Use an eyelet punch to open a keyhole buttonhole.
!3 Pin
!4 Seam ripper
42
Tabla de contenido

Solución de problemas

loading

Tabla de contenido