Putting Into Service - Grohe Blue Starter Kit 33 249 Manual De Instalación

Electrical test data
• Software class:
• Contamination class:
• Rated surge voltage:
• Temperature for ball impact test:
The test for electromagnetic compatibility
(interference emission test) was performed at the
rated voltage and rated current.
Approval and conformity
This product conforms to the requirements
of the relevant EU guidelines.
The conformity declarations can be obtained from
the following address:
GROHE Deutschland Vertriebs GmbH
Zur Porta 9
D-32457 Porta Westfalica (Germany)
Installation
Important:
Risk of damage:
– Installation of the fitting and filter
cartridge is only permitted in frost-free
rooms.
– Flush pipes thoroughly before and after
installation in compliance with EN 806.
– The control unit is only suitable for
indoor use.
» Install kitchen fitting, see Figs. 1 and 2 on
fold-out page II.
When installing on the sink, use the enclosed
support plate (1), see Fig. 1. Insert fitting into
sink (for hole diameter see fold-out page VI).
Feed through hoses one at a time. Do not
damage hoses, see Fig. 2.
» Install wall holder, see (1) in Fig. 3.
Choose suitable screws.
» Set water hardness at filter head, see (1) in
Fig. 4.
Set water harness at bypass setting to local
conditions, see table on fold-out page IV. The
relevant water supplier can provide information
on the water hardness.
6
» Insert filter head, see (2) in Fig. 4.
» Insert filter cartridge, see Fig. 5:
The filter head (2) can be swivelled forwards by
A
up to 90° in the wall holder (1) to install the
2
cartridge.
2500 V
1. Remove protective cover (5) and insert filter
100 °C
cartridge (4) into filter head to the stop. Note
the installation position of the filter cartridge.
2. Turn locking handle (3) until filter cartridge is
felt locking into place.
» Install control unit, see Fig. 6 on fold-out
page III.
» Connect plug-in connector of fitting to
plug-in connector of control unit, see Fig. 7.
» Connect fitting, see Figs. 2 and 8:
1. Connect the pressure hose marked red to the
left service valve (hot water).
2. Fit connector (2) onto service valve on right
(cold water).
3. Connect the two short pressure hoses marked
blue (arrows point towards the fitting) to
connector.
4. Connect the long pressure hose marked blue
(arrow points towards the filter) to filter
head (1) [IN].
5. Connect the long pressure hose marked blue
(arrow points away from the filter towards
the fitting) to filter head (1) [OUT].
» Open hot and cold water supply and check
that connections are watertight.

Putting into service

» Flush filter cartridge, see Fig. 9:
1. Place collecting vessel (at least 2-litre
capacity) under filter to collect the water
flowing out of the hose (3).
2. Open rotation handle (1).
3. Press flush valve (2) on filter head and flush
filter system.
4. Continue flushing until the water emerging
from the hose is clear and free of bubbles
(at least 2 litres).
5. Close rotation handle.
» Connect power supply, see Fig. 10 on fold-out
page IV.
The red and green indicator lamps flash on and
off a number of times and then remain on.