Festool KA 65 Manual De Instrucciones página 19

[1-20]
Display
[1-21] Refill button
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Operation
WARNING
Unauthorised voltage or frequency!
Risk of accident
The mains voltage and the frequency of the pow-

er source must correspond with the specifica-
tions on the machine's name plate.
In North America, only Festool machines with

the voltage specifications 120 V/60 Hz may be
used.
6.1 Initial operation
Remove protective foil from underneath the

support base [1-17] and display [1-20].
The machine may generate large quantities
of smoke and a pungent odour when operat-
ed for the first time.
Do not use the machine and working materi-
als below 15 °C. Recommendation: room
temperature.
6.2 Preparing for operation
Install the support base [2].

Insert the plug into an earthed socket.

Insert a minimum of two adhesive cartridges in

the magazine (chapter 8.2).
Set the heating temperature for the relevant ad-

hesive cartridges.
Temperature selection [1-7] according to the de-
fault setting:
Setting 1 = 190 °C
Setting 2 = 200 °C
The temperature can be adjusted by pressing
the menu buttons [1-19] (chapter 7.2). After
independent changes are made, the last
temperature used is automatically saved to the se-
lected setting and replaces the default setting.
6.3 Switching on
Press the on/off switch [1-8] once and hold until

the Festool logo appears on the display [1-20].
The machine increases the temperature in heating
mode until the setpoint temperature is reached
(display [1-20] lights up red).
Machine switches to warming phase (display [1-20]
flashes red/green).
Machine is ready for operation (display [1-20] lights
up green).
NOTE
Do not leave the machine unattended!
When taking a break of less than 15 minutes,

switch the machine to cooling mode (chapter
6.4).
When taking a longer break, switch off the ma-

chine completely.
6.4 Switching off
Press the on/off switch [1-8] < 1 s

The machine reduces the temperature in cooling
mode and then switches off.
Display [1-20] lights up red, fan symbol is dis-
played.
Press the on/off switch [1-8] and hold > 1 s

The machine switches off immediately.
7 Settings
7.1 Adjusting the edge height [3]
The edge height can only be adjusted at op-
erating temperature! Ignoring this instruc-
tion may result in machine damage.
Guide the edge band [3-2] into the edge in-

let [3-3].
Use the rotary knob [3-1] to adjust the height of

the edge inlet [3-3] until the edge band [3-2]
rests against the top and bottom of the inlet.
Turn back the rotary knob by one locking posi-

tion so that the edge band [3-2] can slide
through smoothly without becoming caught.
7.2 Adapting the adhesive quantity
The necessary adhesive quantity is automatically
adjusted to the current edge height.
Press the menu buttons [1-19] to adapt the adhe-
sive quantity (layer thickness) to different work-
piece materials (chapter 7.2).
7.3 Selecting the feed speed
The feed speed can be adjusted and adapted to the
contour of the workpiece at any time by pressing
the button [1-2] .
1st gear = 2 m/min
2nd gear = 4 m/min
KA 65 GB
17