Activating/Deactivating The Alarm - Hama RC 550 Instrucciones De Uso

Note – 12/24-hour format
• The time is displayed in 12-hour format as standard. The radio signal icon will
disappear as soon as you change the time display to 24-hours format. The
alarm clock will automatically search for the radio signal again at the next
interval (usually at 2:00/3:00 o'clock in the morning). The icon will be displayed
again as usual when a radio signal is received successfully.
• If the radio icon should still not appear, change the installation location
and avoid areas with possible sources of interference (cordless and mobile
telephones, wireless speakers, WLAN, etc.), if necessary.
5.3. Alarm
Setting the alarm time
• Press and hold the ALARM button (3) for approx. 2 seconds until the hours display
(B – 9) begins to flash.
• Set the following information in the order listed:
• Hours
• Minutes
• To select the individual values, press the
confirm your selection by pressing the ALARM button (3).
• If you do not make an entry for 30 seconds, the device automatically exits the
settings mode and the settings you made are saved.
• Press the ALARM button (3) to display the set alarm time for approx. 5 seconds.

Activating/deactivating the alarm

• Move the ALARM ON/OFF slide switch (4) to the left to the ON position. A red
surface will be visible underneath the slide switch.
• The alarm is activated and the alarm clock icon (B – 11) is shown on the display (1).
• Move the ALARM ON/OFF slide switch (4) to the OFF position to the right until the
surface underneath the slide switch is black.
• The alarm is deactivated and the alarm clock icon (B – 11) disappears from the
display (1).
8
Alarm time (B – 9)
button (5) or the button (6) and