Moving Rail Fitting; Blind Panel Fitting - Dometic SKYSOL Instrucciones De Montaje

Installation
7.3.2 Frame fitting
A
NOTICE! Risk of damage
• Use packing material where required (fig. 3, page 4).
• Use suitable screws and plugs for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.The heads of screws may be no
larger than 6.0 mm in diameter.
• Ensure not to drill through the wall.
• Ensure not to damage the channel in the side tracks.
• Consider using two people to install the product if the blind is large or the
installation location is difficult to reach alone.
• Take care not to leave screws or other debris inside the side tracks as this
can jam the shoes in the tracks.
Proceed as shown (fig. 6, page 5):
➤ Align the blind with the window cut-out and mark where the holes are to be
drilled for the frame.
➤ Fix the frame with the screws to the ceiling (2.).
It might be easier to loosely fit the four corner screws (1.) first to position and
hold the blind while the main fixings (3.) are fitted.
If fitting a curved frame position the blind vertically using the side track
screws rather than the corner screws.
7.3.3 Connecting the motor
➤ Connect the motor as shown:
– Manually switched blinds (fig. 7, page 6).
– Remotely controlled blinds (fig. 8, page 6) or
– Using other control system (fig. 9, page 7)
7.3.4

Moving rail fitting

➤ Proceed as shown (fig. 0, page 8).
Dependent on the version the blind is equipped with one or two moving
rails.
7.3.5

Blind panel fitting

A
NOTICE! Risk of damage
Ensure that the cording on each panel is routed correctly (fig. b, page 9).
Always extend the fabric panels completely before clipping them in. This pulls
the cords tight and prevents them from dropping and potentially getting
trapped when being clipped in.
24
Powered Roofblind
EN