Settings; Initiating Setting Mode - Sony WRT-847A Manual De Instrucciones

Settings

For the transmitting channels and frequencies selectable on
your transmitter, see the "Sony Wireless Microphone System
Frequency List" supplied with this manual.

Initiating Setting Mode

Enter Setting mode to change the transmitting channel, the
transmitting frequency, the audio gain level, the compander
time constant and the RF output power, or to reset the
accumulated battery use time indication.
To enter Setting mode
While holding down the SET button, set the POWER switch
to ON.
Hold the SET button down until an indication appears on the
LCD display.
The transmitter enters Setting mode and the indication
before the transmitter was previously turned OFF flashes on
the LCD display.
Pressing the SET button cycles the setting modes in the
order shown in the figure on the right column.
Note
On the model available in Europe, the transmitting channels
are grouped in four sets as shown in "Sony Wireless
Microphone System Frequency List".
8
(GB)
Display of the transmitting channel/frequency shows that of the
CE62 model as an example.
Transmitting
channel 1)
Transmitting frequency
Audio gain level
Accumulated battery use
time
Compander time
constant
RF output power
1) On the model available in Europe, the transmitting-
channel indication flashes in two steps; first, the left two
digits flash for setting the channel-group number, then the
remaining four digits flash for setting the channel number.
Press SET
button.