Tabla de contenido
Idiomas disponibles
Idiomas disponibles
M
ounting the generator and steam supply pipe:
T
he steam generator can be floor standing or wall mounted using the L-brackets (included in package).
When mounting the steam generator to the wall use the keyhole slots in the L-bracket
Use suitable screws according to wall material and local standards.
NOTE:
HELO HSX-steam generator's weight when filled
Check construction instruction when fastening the steam generator to wall for p
fastening.
W
hen using the optional drain valve, wall mounting is recommendable for proper downhill gradient for
the drain pipe.
Copper tube, 15
mm, is recommended as steam pipe from the steam generator to the steam room.
The steam pipe shall run in a straight downhill- or uphill gradient from the steam generator to the
room. Avoid any "water pockets" or other dips in the steam feed pipe on its route to the steam-nozzle as
these will collect condensed water and block the pipe.
Condensation should be able to run on a downhill gradi
the generator is mounted above the level of the steam nozzle, or run back to the steam generator on a
downhill gradient from the steam nozzle to the generator if the generator is mounted below the level o
steam nozzle.
N
OTE: It is recommended to insulate the steam feed pipe for safety reason and to avoid heat
loss /condensation.
WARNING: Hot steam can cause burn injuries.
T
he magnetic valve for draining the steam generator tank is fitted into the draining pipe. Alternatively you
may use a manual draining valve.
T
he steam generator tank should be drained after each use. Draining extends steam generator's
service life and reduces chalk build-up.
with water is approx. 17 kg.
ent from the steam generator to the steam room if
roper
steam
f the
6
Tabla de contenido
