Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE AND INSTALLATION:
The HSX steam generator is only intended for use in the heating of steambaths. Use of the steam
generator in any space other than intended can result in structural damage.
The manufacturer is not liable for any damages caused by installation in a space not intended for
steambath use, or misure of the generator.
Water and steam pipe connections must be made prior to connecting the unit into the mains.
Due care and attention must be taken when making the connections. Ensure that all joints are properly
sealed. Although thread seal tape can be used to properly seal threaded joints, soldering the joints is
recommended.
The steam generator must be placed away from water and moisture (dry room). The room must be well-
ventilated as the steam generator also generates heat. The minimum recommended safety clearance on
each side and above the generator is 30 cm. When placing the steam generator, also take into
consideration the space required for its maintenance.
There should be a drain nearby for draining the tank.
The steam generator can be installed freestanding on the floor or on the wall using wall fittings.
When using wall fittings, ensure you use appropriate fittings and screws for the type of construction
material of your walls. The steam generator weighs about 17 kg when filled with water.
When the automatic drain valve is used, it is recommended you use wall installation to ensure the proper
discharge pressure in the discharge pipe leading into the drain.
4
Tabla de contenido
