Cooling Mode; Roof Heating Mode; Heating By Convyors; Air Refreshment - Spheros CC 305 Manual Del Proprietário

1.2.6 COOLING MODE

After selecting the 'automatic mode' according to item 1.2.4 and if the internal
temperature of the vehicle is above the set-point, the equipment will start iate
operating in the 'cooling mode' automatically
Whenever the systems starts up in 'cooling mode' the evaporator's blowers
will start on 'automatic mode'. Houever, the ventilation speeds may be
changed manually (see item 1.2.5).
Note: The evaporator's blowers are activated in the automatic mode,
according to the set-point programming.
1.2.7 ROOF HEATING
1 - After selecting the 'automatic mode' according to item 1.2.4, and providing
the internal temperature of the vehicle is below the set-point, the equipment
will start operating in the 'roof-reating mode'.
Note: In this mode, the ventilation will operate only at low speed.
1.2.8 HEATING BY CONVEYORS*
The 'heating mode by conveyors' is activated in the same way as the 'roof-
heating mode'.
*Conveyors – Heating coils installed by the body manufactures. They ar normally located along the side
passenger's saloon, below the seat.
23

1.2.9 AIR REFRESHMENT

1 - With the air conditioner running on 'automatic mode', the refreshment will
work according to the set-point temprature, searching for the most
comfortable conditions for passengers.
This is both 'cooling mode' as well as 'heating mode'.
a) The indicator (12) will turn on to display when the refreshment is open and
will turn off to diaplay when it is closed.
2 - During the cooling or heating, the air refreshment can be manually
activeted pressing the key (RENOV). It will remain open for 10 seconds. After
this period it will close automatically, going back to the automatic cycle.
Note: Should the air refreshment be open when the 'cooling mode' starts to
work, it will be automatically closed.

1.2.10 INTERNAL AND EXTERNAL TEMPERATURE

The display will normally show the internal temperature of the vehicle.
1 - to verify the external temperature press key (TEMP). The display will show
the external temperature for 5 seconds. While the external temperature is
shown on the dispay, the indicator (13) will be on.
After 5 seconds the display will return showing the internal temperature and
the indicator (13) will be of.
If the key (TEMP) is pressed before the pre-determined period of 5 seconds,
the display will show the internal temperature again.
Operating the air conditioner