KNOWING YOUr JIG SAW
1. Trigger Switch
2. Lock-On Button
3. Variable-Speed Dial
4. Blade Holder
5. Base
6. Chip Shield Rod
7. Roller Guide
8. Vacuum Adaptor
9. Allen Key Holder
10. Orbital Setting Selector
UNPACKING AND CONTENTS
IMPOrTANT:
Due to modern mass production techniques, it is unlikely the tool is
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Jig Saw
Wood-Cutting Blade
Metal-Cutting Blade
Rip Guide
ASSEMBLY AND ADJUSTMENTS
WArNING:
adjusting, adding accessories, or checking a function on the tool.
BLADE INSTALLATION AND REMOVAL (FIG 2)
CAUTION:
Always clean out all chips or foreign matter adhering
to the blade and/or blade holder. failure to do so may cause
insufficient tightening of the blade, resulting in a serious personal
injury. Do not touch the blade or the workpiece immediately after
operation; they may be extremely hot and could burn your skin.
Always secure the blade firmly. Insufficient tightening of the blade
may cause blade breakage or serious personal injury.
NOTE:
use only T-Shank jig saw blades.
To Install the Blade:
1. Open the blade holder by rotating the spring loaded lever clockwise.
2. With the blade teeth facing forward, insert the blade into the blade holder as far as it will go.
3. Check to make sure the back edge of the blade is positioned properly in the groove of the roller guide.
4. Release the holder lever. The blade should now be secured in the blade holder.
To Remove the Blade:
CAUTION:
Make sure the blade is securely fastened each time before using the saw.
4
11
Q'ty
Description
1
Vacuum Adaptor
1
Allen Wrench
1
Operartor's Manual
1
Always be sure that the tool is switched off and unplugged before
Rotate the spring loaded lever clockwise. Pull the blade out of the blade holder.
3
1
10
7
6
Q'ty
1
1
1
FIG 2
2
9
8
5
FIG 1
BLADE HOLDER
ROLLER GUIDE
SPRING LEVER
7