Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE: We recommend that the heater be installed level. Keep gas hose away from hot surfaces.
The heater is attached to a winch cable used for raising and lowering.
In addition, a safety cable or chain (not supplied) is required to be attached to the suspension hooks to
prevent the heater from falling to the litter if the cable should happen to break.
The heater must be located so there is a minimum clearance to combustible material of 24' (minimum of 12'
if the heat deflectors are used) above the heater and 48" from the side.
The heater should be hung with a minimum of 72" from the bottom of the heater and the floor.
We require a minimum clearance of 12" from the heater to the fuel and electricity supply lines.
The installer MUST comply with all applicable local, state, and federal gas codes and regulations.
Always allow heater to cool off before winching unit up to ceiling!
:
Materials that come in close proximity to hot surfaces may ignite.
Tunnel Fan End
For additional manuals or more information, see our website at
SUSPENDING THE HEATER
HEATER SAFETY CLEARENCE
Control end should be on end toward Tunnel Fans
12"
Gas and Electrical Supply Lines
www.ctbinc.com
10
Tabla de contenido
