Leckey Squiggles Instrucciones De Usuario página 6

7.3 Attaching the
footrest
To attach the footrest to the seat base,
remove the bolt and nut from the metal stem
on the footrest. Then slide the metal tube
into the moulding as shown. When the hole
in the metal plate is aligned with the hole in
the moulding, replace the bolt and secure
with the nut provided. Make sure
the end of the bolt protrudes from the end
of the nut.
You can now attach the seat to your chassis
and complete the assembly of the product
and any accessories you have ordered.
Always make sure the foot plate is
attached firmly.
7.4 Attaching the seating system to
the Hi-Low or the Easy Chassis.
Adjust the height of the chassis to its
maximum to reduce risk of back strain while
attaching the seat unit. Refer to Section 11
on how to adjust the height of the chassis
you have purchased.
First release the safety locking pin (A) at the
front of the seat. To do this pull the pin out
and rotate through 90 degrees. Carefully lift
the seat and place it into the chassis. At the
rear of the underside of the seat you will see
a receiving channel (B). Place this securely
over the tube (C) towards the back of the
chassis. Pull the handle (D) at the front of the
seat unit up and then pivot the seat forward
and down. Once the front of the seat is
lowered fully, release the handle and push it
forward to ensure it has fully engaged on the
front tube. Rotate the safety locking pin so
it engages in front of the handle. If it hits the
handle then the seat is not inserted properly,
remove and repeat process outlined above.
D
A
Always check the handle is fully engaged
before you place the child in the seating
system. If the handle is not engaged
properly the seat unit can come loose
and could cause serious injury to the
child or carer.
B
C