Starting Operation - Bosch IXO Instrucciones De Servicio

OBJ_DOKU-6712-002.fm Page 17 Monday, May 14, 2007 11:47 AM
Torque Attachment/Angle Driver Head
(see figures C – F)
With the torque presetting ring 13on the torque attach-
ment 12, the requested torque can be preset in
10 steps. With the correct setting, the tool bit is
stopped as soon as the screw is driven flush into the
material or when the set torque is reached.
With the angle driver head 15 it is possible to carry out
screwdriving applications at hard to reach locations.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3
off toward the front. Afterwards the attachments can be
mounted. The attachments can be mounted offset by
45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring 16
in rotation direction and pull the attachment off
toward the front. Afterwards, mount the rubber cap 3
again.
Operation

Starting Operation

Reversing the Rotational Direction
The rotational direction switch 9 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 8 actuated.
Right rotation: For driving in screws, push the rota-
tional direction switch 9 left to the stop.
The indicator for right rotation 4 lights up when
the On/Off switch 8 is actuated and the motor
is running.
Left Rotation: For loosening or unscrewing screws,
push the rotational direction switch 9 right to the stop.
The indicator for left rotation 6 lights up when
the On/Off switch 8 is actuated and the motor
is running.
2 609 002 415 • 14.5.07
Switching On and Off
To start the machine, press the On/Off switch 8 and
keep it depressed.
The power light 10 lights up when the On/Off switch 8
is slightly depressed, and enables illumination of the
screwing location in unfavourable light conditions.
To switch off the machine, release the On/Off switch
8.
Fully automatic spindle locking (Auto-lock)
The drill spindle is locked when the On/Off switch 8 is
not pressed.
This enables screws to be screwed in, even when the
battery is empty and allows for the machine to be used
as a screwdriver.
When the drilling spindle is locked, do not
press the On/Off switch 8 for more than 15
seconds. Otherwise the power tool can be
damaged.
Operating Instructions
Apply the power tool to the screw only when
it is switched off. Rotating tool inserts can slip off.
Up to 13 screwdriver bits can be stored on the side of
the battery charger 11. The fixture that holds the screw-
driver bits can be removed.
Soft Grip
The gripping surface (soft grip) 7 reduces the danger
of slipping and thereby improves the grip on the
machine and the handling.
At the same time, the rubber coating achieves a vibra-
tion-reducing effect.
Wall-mounting the Battery Charger
(see figure G)
The battery charger 11 can be mounted to a wall. For
this, hang the charger via the slots on the side onto two
screws.
English | 17